As all us know that the capacitor panel is connected to improve the power factor when it is PF is low. whether we can connect the capacitor panel on D.G. side(? If it is yes means why?
1 6379HOW TO CALCULATE THE CAPACITOR RANGE FOR LOAD FOR PF IMPROVEMENT? EXPLE:FOR 65 HP LOAD HOW TO CALCULATE CAPACITOR RANGE?
Al-Malik, All Star Electric, GEC, Reliance, Universal Industries,
12 46145what is full form of lv and mv? 2.while we connect capacitor to generator what will cause for it?
4 32037how to find motor contactor rating and bimetalic relay rating? of 30kw motor which will operate on star-delta starter?
6 21603hw to find transformer is in normal position? whether its in charged condition or not? except humming sound?
ABB,
9 14243How can we calculate the fault level of the distribution system knowing the percentage impedance of transformer & subsequent equipments.
14 59986whether the generating voltage can be made to be transmitted by means of signals to the recieved end or at the consumers end?
TCS,
6 9432Post New Electrical Engineering Questions
why using transformer and thyristor switch in 3 phase apfc panel
What is the function of NER and NET?
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
What is dynamo?How it works and what is the function of dynamo in a DG.
What is center gravity load in substation?
what are the main applications of transistor in non-linear region?
What is the formula to calculate distribution transformer De-rating on iron losses basis
What is knee point voltage of transformer?
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
What is the difference between the transmission line and distribution line?
What is EMC filter in VVVF Drive ?
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
why we have and use 3 phase not 2 or 4 or other in power system?