Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) When the DG is running at the time we can connect to capacitor banK? why it is required or not
1 290310 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
2679Describe how a salient pole / projecting pole rotor differs from a cylindrical rotor and state the application of each rotor respectively
3 6157Hello sir i had completed my BE in production engg.After diploma in mechanical engg.now i want to do BE in mechanical engg.that is double degree.Anyone can please tell me is there any provision to do this and how much is course duration.
1 3730there is one orifice plate already installed on 3" line, but my previous engineer(who is not working here) removed that tx, but now i want to take it in to the process, so now what i have to do now? flow fluid is hytherm oil of temp. 260deg & pressure is 3bar.
2 5707A ground is nonengginered fill 15 years back; how we can find the level of consolidation and bearing capacity
2 5533
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
what are the disadvantages in GIS over AIS
can we calculate the voltage level for microwave energy which is using for our mobile communication?
how mass curve differs from hydrograph.
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
hello sir iam atul joshi from mechanical branch. i want to know about the syllabus of technical ques of jindal steel
What is the release of lien?
How the sizing of the analog signal cable is calculate?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
What is the effect of if in radio receiver?
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
what is the difference between neutral and earth
why u r living from presentaly working.
How to stoped water tube boiler
What is wool dyeing?