Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) Whether the Dc motor Droping the power factor like AC motor if lot of motor running in factory is it necessary to connect capacitor bank
2 4638what is restircted earth fault relay,how it works? what is diffrance btwn normal earth falut relay & restricted earth fault relay?
1 5727which case we find maximum pressure & flow in centrifugal pump - circular casing or volute casing?
1 3659what is procedure of measuring operating length of mechanical seal .(in case of centrifugal pump)?
2245. how will effect of water injection on turbine load and corresponding MW output(not water washing)
1945Which view provides a clear indication of an object, isometric or orthographic, and why ????
TATA,
4 8057
Enlists the applications of sampled data systems?
What is meant by derating factor?
how can determine grounded motor when it alarm at 440volt
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
What is the expansion of scada?
What happens when an ammeter is connected across the circuit?
Based on the Job Description above, please indicate in details why you are a good match for this position?
What are some common causes of control valve noise?
Is boiler a closed system?
what is static identifier in c language?
What if the difference beween internal and exrteranal LBB?
Causes of M/E high exhaust valve temperature
IS THE SAMPLE POINT OF LPG SPHERE TANK PEFOR OR AFTER BUMP?
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
What is the basis for classifying a material as a conductor, semiconductor, or a dielectric? Define what is the conductivity of perfect dielectric?