Whether the Dc motor Droping the power factor like AC motor
if lot of motor running in factory is it necessary to
connect capacitor bank
Answers were Sorted based on User's Feedback
Answer / bhusha
dc motor never drop the power factor of the motor because
in case of dc any circuit behaves as a resistive circuit.
if number of induction motors are connected then power
factor is drop, therefor it is necessary to connect power
factor correcting capacitor banks across motors.
| Is This Answer Correct ? | 1 Yes | 0 No |
no, the dc motor doesnt drop thr power factor because no
induction effect is there in dc motor i.e. does not
generate reactive power
| Is This Answer Correct ? | 0 Yes | 1 No |
How does a television work?
Can any body tell gulf interview question for experienced electrical engineer ?
how to take the 3 phase ups input and collect single phase output
E.B sending end to receiving end 33kv ug cable laid 8Km,receiving end to ss1,ss2,ss3,ss4 all are Approx 800 Mtr,can go for 33KV to 430V or 33kv to 11kv in receiving end and 11kv to 430 near ss ,which one is good for technically and economically.
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?
WHY THE FREQUENCY IS 50 HZ IN INDIA.CAN WE USE SOME OTHER FREQUENCY.IF SO WHAT IS THE RANGE AND WHAT WILL BE THE EFFECT IN PRESENT POWER SYSTEM IF WE CHANGE THE FREQUENCY AS YOU SUGGEST ?
32 Answers L&T, MCL,
how can i increase the excitation on full load running engine??
why transformer ratings in kva?
99 Answers Bhel, College School Exams Tests, DOW, Emco, Esab, GE, KCP, PGCVL, Sodexo, TCS, vtps, Wipro,
For a Potential Transformer(PT), the primary neutral terminal must be grounded before energization. Why....? What will be heppend if we energize the PT without grounded the primary neutral point? Why..........?
why a motor overheated stops to rotate ?????
Why we are always only used 11 kv. , 22 kv ,33kv in transmission line? Why not use 25, 55 ,65 kv ?
3 Answers Khidmah LLC, Precision Camshafts Limited,
CAN ANYBODY EXPLAIN WHAT ACTUALLY MEAN BY THE PHASE DEFFRENCE? R,L,C CIRCUITS?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)