Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) what is the function of a circuit breaker ?how does the circuit breaker function during normal operation of an electrical system
2 3890why r u using enjine oil inside of diesel generaters.what is the uses & why r using diesel by pass filter. plese kindly answer me sir..?
2027how ratio is calculated for any grade of concrete. for e.g. sppose M20 requires(x;y:z) quantity of cememt sand and aggregate.
2098How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
1823
What id difference between power and energy?
Reverse the link list without creating new list ?
What are the responsibilities of a site manager?
What are the two methods of control in ac voltage controllers?
if i used salt as a add mixture in concrete, then what will happen and what are the naturally available add mixtures.
What pressure is highest L.O. Gravity Head or S.W. of the stern tube circulation
Does the motor power displayed on the Motor name plate is the mechnical power motor delivers or it is consumed power from the system?
Whay we use gigabite ethernt
What were the most energizing/enjoyable aspects of your job in this given period?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
4. Differentiate between NC and OC soils. Draw curves for (i) Stress vs Strain (ii) Volume charge vs Strain (iii) Pore pressure vs Strain for these soils
What are daemon Threads?
Explain counter sample.
funtionalities of loadining and linking
What OPGW is better than Microwave or PLCC???