Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) what do you mean by Loop checking ? What are the cold loop check and hot loop check? what are the difference between these two loops?
1 8379In case of AHU ,how to arrive at chilled water USGPM of the AHU in case the AHU CFM is given. Can some HVAC genius please advise.
SR,
3 17120If a transmitter is installed 10 m below its tapping point how much pressure exerted if fluid is water?
10 15812
Describe a time when you identified and mitigated a safety hazard in a manufacturing process.
Tell me why gold is added to the p-n junction?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
what are the difference between AC lamp and DC lamp
is oil viscosity affect on motor current?
what is the differences between DTD's and XML schema?
what is cyclon vibration effect in turbine
What is a feasibility study?
why transformer ratings in kva? & DG ratings in kva? & Motor ratings in kw/HP?
Define convection.
Q- What are the application in which PNP transistor is preferred over NPN ?
Explain the hooke`s coupling.
Hook up resistance decade box to temp.transmitter.
Calculate the interstage pressure ratio per stage for a two stage compressor if the overall pressure ratio is 10.
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks