If a ACB breaker is tripping and closing problem, then what will we check internal..?
Answers were Sorted based on User's Feedback
Check the overload current settings, and also check if any cable is faulty or grounded?.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / naveen joshi
closing and tripping of Acb (for local and remote) associated with coil (uv, shunt,closing) check wheather proper continuos supply to uv coil and closing and tripping circuit to the coil.if not works than it's breaker mechanism should be checked.
| Is This Answer Correct ? | 0 Yes | 0 No |
What is the purpose of REACTOR in GIS substation?
Can we step up a 230V supply to 400V using a single phase transformer??
when neutral will carry the current?what could be the magnitude?
why dont we connect the two 12 V DC batteries in parallel, for an inverter (UPS)? is there any harm ?
difference between alternator & GENERATOR
What is the Difference Between MCCB & ACB & VCB
why PT Primary are the grounded?
Is it necessary to seperate the DG earth grid with Electricity Board earth grid for protecting the DG set. if yes why?
the distance from my office to d.g is aprox 400mtrs and voltage drops ibn my office near about 40 volt what should i do p[ls suggest.
WHAT IS THE REASON,WE USED THREE CORE CABLE INSTEAD OF THREE SINGLE CORE CABLE.
Who we calculate the generator NGR resistant, generator voltage 11 KV ?
Why does capacitor block dc supply?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)