2. The heaviest and lightest strings on a certain violin have linear densities of 3.0 and 0.29 g/m. What is the ratio of the diameter of the heaviest string to that of the lightest string, assuming that the strings are of the same material?
1 4021Write a program to maintain a singly linked list having the following functions: a) Creation of the list b) Displaying the list. c) Swap all nodes at consecutive even odd positions. E.g.: The nodes at position 1 should be swapped with node 2, node 3 with node 4 and so on.
7101why do some transmission towers have two insulators at one side and three insulators at the other side
2 3802sir iam a 3rd yr eee student.no core company comes for recruitment to our college.my aim is to be placed in l and t.tell me the procedures.
1517I am having a DG set.The 415 V from Generator is step up to 460 v and then the same is used for Induction furnace. before Step up, I am connecting LT load to my factory use. When Induction furnace is in service from DG, when i try to start a motor, the generator is tripped.Please tell me the reason.
3 4474cement required for construction of 400mm*200mm*200mm concrete solid blocks for 1sq.mtrs,how?
L&T,
1893There is a problem with our HART475 it is not communicating with smart devices error becomes "NO DEVICE FOUND"we have insert 250ohm resistance as per requirement but invain plz tell me the solution?
1 6182we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
1287
EXPLAIN WHY YOU CONSIDER YOURSELF SUITED FOR THIS POSITION:
wat is the first thing dat is needed, 2 lay a cable in some area??
What is meant by input power factor in controlled rectifier?
what is circuit breaker in transfomer and where it used
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
how can decide the current rating of oltc
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
interview questiions for production planning
how to calculate the strength of rebound hammer test reading in building construction ?
Discuss the basic functionioning of air conditioner.
Decibel.
What is stop band?
Give two advantages of csi?
How many lightning arrestors to be installed on 50MX60MX10M building and is there any formular for that?
Difference ISDN and Brodband?