Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) For amonia manufacturing process if pressure, temperature would be increase over optimum level what would be happen?And what steps should be taken?
2229why spur gear making noise douring running, why spur gear teeth get crack, what is the effect of heat treatment on spur gear how to reduce the noise bet gear
1 3606What is the relation between the Peripheral speed(N) , no.of poles(P) and diameter(D) of a cylindrical rotor alternator ?
NTPC,
5 13163
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
how will we calculate the copper wire load..
Define Electrical Insulation and examples of Solid,Liquid and Gaseous insulating materials?
We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
what is procedur of getting job in oracle for freshar engineer.
The inventer is a battery, but if lost current at home u will turn on the fan but the is AC and inventer battery is dc . Then how the fan was rotating. What device Or machine in fan converst the Dc power to Ac power
what is temperature compensation?
how to calculate the settings for shaft ct protn in hydro generators
Explain the differences between microprocessor and micro controller?
What does the voltmeter in ac mode show? Is it rms value or peak value?
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
what is pile and deam foundation
What is a good relation to use for calculating tube bundle diameter?
may i know the detailed description of cutting length