Interested to Buy Any Domain ? << Click Here >> for more details...
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
What is the major difference between Normal control loop and Cascade control loop and when to use cascade control loop?
3382Diploma Mechanical Engineer i had attened more over 100 interviews they are all asking the same question "TELL ME ABOUT YOURSELF"
Automobile, Bajaj, Blue Star, Dr Reddys, Escorts, Honda, Indian Ordnance Factory, Maruti Suzuki, Micro Resources, Neyveli Lignite Corporation, Nissan, Ordnance Factories Board, Polytechnic, Rashmi, Reliance, Steel Plant, TATA, Tata Marcopolo, Tata Motors, Tata Steel Limited, TCS, Toyota, TVS,
3 618271.WHAT ARE TRANSMISSION LINE LOSSES DURING WINTER AND SUMMER SEASON? 2.WHAT ARE THE CAUSES/ 3.WHEN THE CORONA IS MORE?.,WHETHER WINTER OR SUMMER? 4. WHAT IS THE PERCENTAGE OF LOSSES IN TRANSMISSION LINE?
1 6788In 3 phase induction motor 1hp current rating is 1.5 amps constant ? is correct or not ?
TATA,
4 17033pls explain me the design procedure of multistorey building including structural analysis and also with example by considering the effect of wind load and earthquake load ?
1 9370what type of loads are inductive load & resistive load ?how they different between each other ?
5 20113How to calculate concrete,s cement, sand, metal on the bases of its ratio. For any volume of work please give me brief calculation
L&T,
5 12404
Give the topology of current amplifier with current shunt feedback?
why we use kg/cm2 instead of kg/m2 as a unit of pressure. As we know kg is a MKS unit and cm is a CGS unit. So why we use combination of both(kg/cm2)while describing the pressure.
What is the formula for figuring out how many gallons of water are in a pipe by the foot?
what is recursion in c language?
How to calculate the area in squarefeets ?How much area of sqft for this measurements?East 53.3ft West 54ft North 47.7ft South 51.1ft ?
What is the ideal position cooling fan inside the dc motor?
How many mosfet switches are there in dynamic ram?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
Calibration of controller (pneumatic)
consiteunts of indian railways
hi frenz,its aswathy.i hve aplied for the hpcl test on feb,pls send the test patern & the placement papers as soon as possible. mail-id :kjaswathy@gmail.com
please can any one send me BHEL ECE sample papers
sir i had plane to do some project with the base of hopkinson test in AC supply its possible
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
What are the steps involved in how to design a garment?
