Answer / suhas

six sigma gives wide range of dispersion so that large no
of item get selected and it is less in 3 sigma

Answer / arul

1) Sigma means the standard deviation of the data obtained.
Eg: Turning a shaft for 50mm will never give 50.0000000mm.
There will be variation in the machined dimension. For
measuring the variations v use the parameter standars
deviation. RMS (root mean square) of the deviations from
the mean vaue is standard devation.
2) All the manufacturing & m/c dimensions can be
approximated to lie in a normal curve (bell shaped curve
symm about mean and showing max. freq at mean.)
3) Kindly refer to standard normal curve and its values.
U ll surely come to know 6 sig is better than 3 sig

Answer / raju.j

This is about amount of rejection of Parts Per Million(PPM)
products...
In 6sigma industry 3.4parts only rejected i.e defected per
million product....99.9997% products are good.
In 3 sigma industry 2700parts are rejected i.e defect per
million product....

Answer / swapnil borgaonkar

six sigma
mean
most better quality i think its mostly related to better
quality
in india only 2-3 company achieve 3 sigma,no six sigma
achieve in india
3 sigma is less then 6 sigma mean half of 6 sigma .

Answer / pradeep

6-was containg the orbetal was different was determaining
from this ssigma will contined this have many new orbitals
and space contined it was depending upon the 3-sigma was
consisting of them to a sigma
3-sigma was depending on the onther orbetal was determing
the sigma was to be consisting of them to a3-sigma wad
depending on them to consisting on 3-sigma on them to be
obtained them. .

Did you have a favorite project that you had to do while in school?

1 Answers  

---

What is the difference between scavenging and supercharging ?

1 Answers  

---

What does angular momentum mean?

1 Answers  

---

High pressure subtropical calm belts known as ?Horse Latitudes? lies between

0 Answers   RRB,

---

Name the sheet metal hand tools?

1 Answers  

---

which mechanism is used in automobile gearing system

9 Answers   Bosch, NTPC, TATA,

---

What are the causes of L.O. high temperature?

1 Answers   RRB,

---

how much efficiency loss will took place in a steam turbine due to low vacuum

1 Answers   TATA,

---

What materials are used for engine propeller?

1 Answers   RRB,

---

what s available NPSH and required NPSH? which is given by manufacturer and which is not? what is the role of customer in choosing NPSH?

1 Answers   IOCL,

---

define jig and fixure?what is diference between jig and fixure?

12 Answers  

---

A very strange fault i cam across today,that i never experienced not studied before, i need an answer for this. Phase to phase or line to line , L1,L2 & L3, voltages are 490VAC, but if i use line to ground , its again 490 VAC. . . whats the fault and theory behind of it?

1 Answers  

---