A very strange fault i cam across today,that i never
experienced not studied before, i need an answer for this.
Phase to phase or line to line , L1,L2 & L3, voltages are
490VAC, but if i use line to ground , its again 490 VAC. . .
whats the fault and theory behind of it?
No Answer is Posted For this Question
Be the First to Post Answer
DIFFERENCE BETWEEN CODES,STANDARDS & SPECIFIFCATIONS?
tell me about a type when you had to use your presentation skill to influence some ones opinion
What is the use of the governor on diesel generator
5 Answers GLA University, Standard Chartered,
Can I use IS 2062 GR B Material for low temperature application upto -20 C ?
• Why not 4 phase & 5 phase
What will be the cause of scavenging fire?
What is the differences between IC & EC Engines.
what shows avribiations related to bearing blocks
What was the spinning jenny?
Air is a bad conductor of heat.why it becomes hot in summer?
what is unified transmission system
why the compression ratio of the diesel should be high?