Answer / santosh kawade

No.

Core will go in saturation mode,core losses will increase,
which will result in overheating of generator and winding
will burn.

Santosh kawade
9224 69 3116

how to calculate of which rating transformer should be selected? take any example

2 Answers  

---

what happen if the parallel generator phase angle shift by 1 degree in manual mode

0 Answers   EEEC, MEC,

---

What is the output of a transformer..??

1 Answers   Jindal,

---

In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?

0 Answers  

---

what is mean by harmonics?Type of harmonics?

6 Answers  

---

1- XC and the RC time constant are both measures of the reaction of C to a change in ____? 2-The power factor is a numerical ratio with a value between 0 and 1 equal to the ______________ of the phase angle. 3-When V and I are out of phase because of reactance, the product of V times I is called ______________ power 4-For _____________ inductors, the branch currents can be added algebraically. 5- The ______________ power in watts can be calculated as I^2R 6-Calculate XL with L = 30mH and f = 1kHz ( I have Xl=2piFL 2*3.141592653*1kHz*30mH =188 ohms Please check) 7-A parallel RL circuit has the values, R = 5kohms, XL = 5kohms. A voltage source of Vt = 10Vrms is connected in parallel to R and L. Determine the total current, It delivered by the voltage source Vt. 8-A series RC circuit has R = 1Mohm and C = 1microF. How long would it take for the capacitor to fully discharge if it is initially fully charged? 9-A circuit has real power = 300W and an apparent power of 500VA. Determine the power factor and phase angle. 10-The time constant for an LR series circuit is T = 0.1s and R = 10ohms. Calculate the inductance L.

0 Answers  

---

what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero

0 Answers   Jindal,

---

Why voltages are 11kv 33kv why not others?

2 Answers  

---

what is the control circuit for operating the clean room air shower

0 Answers   L&T,

---

Can u start a tube light without a starter?

8 Answers   Adani,

---

what is the IS foe lightning arrester?

0 Answers  

---

How we can measure the thickness of bus bar for a given load ? any farmula Plz elaborate clearly.

2 Answers   ITC Infotech, TCS,

---