8. What do you find more useful in your present work – your
education or your practical experience from previous jobs
or traineeships?
Answers were Sorted based on User's Feedback
Answer / suresh
Both are essential.Education is nothing but the solutions
of practical problems written by experienced
persons.Through education we learn a lot of solutions for a
same problem. By experience we come to know which solution
is suitable for a particular problem to proceed the job
without any obstructions.
| Is This Answer Correct ? | 20 Yes | 0 No |
Answer / sjtbehera
Education gives knowledge of palnning and how to work.
practical knowledge gives how to work speed
| Is This Answer Correct ? | 7 Yes | 1 No |
Answer / n.c.pathan.
Both are important.Education gives you idea about the basic
concepts and training and experience prepares you as to how
to handle the situations under different constraints.Your
committment and attitude makes all the difference when you
reach senior management level.
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / g.a.r
both is important. Education is where you gained your
knowledge and executing that knowledge into reality is your
experience where you can assess youre fficieny and
competency to that skills
| Is This Answer Correct ? | 0 Yes | 0 No |
for construction of 1 cum of brickwork what is requirement of cement, sand and bricks
3 Answers Nirman Consultants, Shapoorji Pallonji Group(SPCL),
how to calculate the number of cement bags required for 1m3 of work
What is OSHA compliance?
Write down a formula to calculate the number of 50Kg bags of cement for moulding of cement blocks of tcm thick by 20cm high by 40cm long on site with a mix ratio of 1 bag of cement to 3 wheelbarrows of sand . the sand is measured at a STRUCK( WATER LEVEL) 65 litres capacity wheelbarrow. TEL: +237 674630019
how much quantity of steel required for 1sqmt area?
4 Answers Jade Software, Samsung,
minor loss due to sudden contraction 1>flow contraction 2>Expanssion of flow after sudden contraction 3>cavitation 4>boundry friction
What is the procedure and technnology behind jointing of prestessed block in Delhi metro rail project.
how to calculate for ramp slop?
What is the OMC and MDD for subgrade (soil),Granular Sub Base, wet Mix Macadam in your project?
What's mean fe of steel?
1 Answers Fernas Constructions,
12 mm dia not available at site for raft, 10 mm are available at site how to calculate?
Plan and schedule for 14 towers of 6 floors each with 6 flats on each floor?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)