can we use 400w coke instead of 250w choke in 250w fittings

Question Posted / n n r

2 Answers
4981 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

can we use 400w coke instead of 250w choke in 250w fittings..

Answer / k.prakashchandra

No.choke decides the power output,being the current
regulator

Is This Answer Correct ?

1 Yes

0 No

can we use 400w coke instead of 250w choke in 250w fittings..

Answer / k.prakashchandra

N0. 400w choke is of lower inductance,hence it will make 250
W lamp draw more current than the rated.

Is This Answer Correct ?

0 Yes

3 No

Post New Answer

More Electrical Engineering Interview Questions

We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?

0 Answers Siemens,

when a hand crancked meggar is used to check most three phase induction motors, how many tests r rquired? Why?

1 Answers

If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.

0 Answers

what must be the mf for a meter with the following conditions. line ct ratio-100/1 line pt ratio- 220kv/110v meter pt ratio- 3X63.5V meter CT ratio- -/1 A

1 Answers

dear all, in motor operation , motor is of 100 hp and bimetal relay setting is 130 amp, if relay is getting tripped on 120 amp balance current what can be the reason? Relay is newly replaced. I dont know but is there any frequency effect in thit case? Can frequency variation affect bimetal relay operation?

1 Answers

What is dynamo?How it works and what is the function of dynamo in a DG.

0 Answers

what is 6 pulse and 12 pulse inverter? Explain brifly

2 Answers

How to improve insulation resistance of Motor

2 Answers

How to calculate Busbar Thickness for Different type of HT/LT panels

1 Answers

What is CBCT ? Why & Where it is used?

14 Answers BCT,

What is the working mechanism of OLTC in Power Transformers????

0 Answers KSEB,

What is the basis for framing the rules of block diagram reduction technique?

0 Answers

For more Electrical Engineering Interview Questions Click Here