can we use 400w coke instead of 250w choke in 250w fittings
- 2 Answers
- 4244 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
No.choke decides the power output,being the current
regulator
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
Dear Sir I am living in Jaipur Rajasthan now I did complete my b tech degree in electrical engineering in 2012 Sir how I gate certificate of competency for electrical supervisor
what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?
What is EMC filter in VVVF Drive ?
what is allowed value of zero sequence impedancce of 6.6 kv nuetral earthing transformer ?what is the actual value
Why Neutral Isolation is required?
why ss stablity limit is more transient stablity limit?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
What is 11 N1 and 12 N2 in single phase Transformer ?
why the projects getting loss?
If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?
Differentiate between low pass, high pass and band pass filter?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
