Follow Our FB Page << CircleMedia.in >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...


When VFD is connected to a 3 phase main supply there is
load current difference between incomer to VFD and outgoing
from VFD.



When VFD is connected to a 3 phase main supply there is load current difference between incomer to..

Answer / pinak

sir,first tell me by what instrument you are measuring the
current,probably clamp meter.the thing is like that in case
of VFD's the incoming frequency is not same as the outgoing
frequency.so due to this change in frequency the current do
changes. sir i hope if you just supply 50Hz on incomming
siode and from the output you are also taking 50 Hz then
the current doesnot changes.

Is This Answer Correct ?    9 Yes 5 No

Post New Answer

More Electrical Engineering Interview Questions

what is a breaker fail relay

0 Answers   Eskom,


hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.

0 Answers   Hyundai,


in dc shunt motor if armature wdg is open then

1 Answers  


How to calculate the value of capacitance of a capacitor used in power factor improvement plant if we know KVAR and voltages?

1 Answers  


in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com

0 Answers  






How can we find the breaking capacity of a Load breaker switch (LBS) fed from 11 kv supply??ex:50KA, 26kA etc???detailed step vice answer pls.

0 Answers  


Maintenance of transformer???

0 Answers   Adani,


what is the full form of KVAR

6 Answers  


List any four conventional sources of energy.

1 Answers  


what are the factors to be considered while design the breaker either HT or LT??

0 Answers  


How to find the maximum load that can supply by a particular(say 315kva) KVA rated transformer?

2 Answers   ME,


what will happen when ac is applied resistor,inductor,capcitor?

1 Answers  






Categories
  • Civil Engineering Interview Questions Civil Engineering (5076)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4445)
  • Electrical Engineering Interview Questions Electrical Engineering (16606)
  • Electronics Communications Interview Questions Electronics Communications (3915)
  • Chemical Engineering Interview Questions Chemical Engineering (1092)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (214)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (258)
  • Instrumentation Interview Questions Instrumentation (2992)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (123)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (0)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1378)