how to consider the lap length of a bar in IS code and specify the code book n

how to consider the lap length of a bar in IS code and
specify the code book name and clause& page number?

Question Posted / manivannan

2 Answers
22552 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

how to consider the lap length of a bar in IS code and specify the code book name and clause& ..

Lap Splices :
Lap Splices shall not be used for bars larger than 36mm
dia. For larger diameters, bars may be welded. In case
welding is not practicable, lapping of bars larger than
36mm may be permitted, in which case additional spirals
should be provided around the lapped bars.

Lap Length in Tension : lap length including anchorage
value of hooks in flexural tension shall be Ld or 30D
whicever is greater and for direct tension 2Ld or 30D
whichever is greater. The straight length of lap shall not
be less than 200mm, whicever is greater.
*Ld - Development Length

Lap Length in Compression : The lap length in compression
shall be equal to the development length in compression
calculated. But shall not be less than 24D

Bars of Different Diameter : When bars of wo different
diameters are to be spliced, the lap length shall be
calculated on the basis of diameter of the smaller bar.

SOURCE : SP34 Hand Book on Concrete Reinforcing and
Detailing --- Clause 4.4.2 lap splices.

Is This Answer Correct ?

14 Yes

4 No

how to consider the lap length of a bar in IS code and specify the code book name and clause& ..

Answer / sjtbehera

it is 50d in thumb rule. but it is diffrent in diffrent
case ex. in compression and tension. lap is not greater
than 36nmm dia.

Is This Answer Correct ?

9 Yes

7 No

Post New Answer

More Civil Engineering Interview Questions

Ratio for 4500 psi concrete

0 Answers

how to estimate material requirement for an area of house in square feet?

0 Answers

which member is very strong (strength) after the cross- section area is same, pipe section or solid rod section ? no that's not my question, my question is why pipe section is strong ?

2 Answers

DO YOU HAVE REFERENCE LIST?

1 Answers

what are the differences between opc cement and ppc cement in applications?

4 Answers NCC,

how many nos of hacking over concrete surface required for 1 sq m area

12 Answers Creative Turnkey Projects, L&T,

What kind of tests will conduct in plastering

6 Answers

What is the unit standard weight,thicknessof C.I>Pipe of various Dia upto200 MM(as per IS1538)

0 Answers Reliance,

why breadth of beam is shorter than (or equal to )its depth?