Interested to Buy Any Domain ? << Click Here >> for more details...
how to consider the lap length of a bar in IS code and
specify the code book name and clause& page number?
- 2 Answers
- 22548 Views
- I also Faced
- E-Mail Answers
Answer Posted / sjtbehera
it is 50d in thumb rule. but it is diffrent in diffrent
case ex. in compression and tension. lap is not greater
than 36nmm dia.
| Is This Answer Correct ? | 9 Yes | 7 No |
Post New Answer View All Answers
Used Cement & Sand in 1 Square Meter or 1 Square Feet For Brick Work 0.115mm ? (1:4) (1:6)
Spider cracks occur in beam bottom due to––
what is the max. area can we apply the plate load test ?
what is the weight of 12mm aggregates?
What is Refuse Area In High Rise Building ?
Are cruise ships built for the transatlantic run?
Formula for calculation volume of essentric footing
Rate analysis of 150mm, 100mm, & 230mm thk BBM work
List out some of the software program that can be useful for architect?
give me the rate analysis for Bituminous Macadam and SDBC
What is the distance between railway tracks?
How do you calculate the power of a centrifugal pump?
What are the govt approvals required for starting of power project. means from initial site grading and excavation work.exm. blasting in hard rock, deep excavation, cut off trees from site.
how much shouid be the rate for ready mix concrete per cubic meter
How much material is required for constructing a 2 Lane 2Km rigid pavement road
