Answer / pswin

It will depends on the type of magger. You can choose desire volt by using selector switch within the range of magger. For low voltage switchboard busbars, 500 V is enough.

Answer / emmanuel

It depends on the technicians choice of voltage. You shoulb
able to get a guess of how much voltage the cable should
be able to0 endure without losing its insulation and then
subject that c abkle to that voltage on the megger. For
low voltage installations about 500V should be okay since
the maximum voltage of a three phase system will be 415V
if bridged.

Answer / simon

5000 v on 140 to 160 R.P.M.

Answer / venkatesh s.r

500v dc

What is surge impedence and surge loading....???

1 Answers  

---

what is the uses of C.V.T transformer in switch yard?

4 Answers   L&T,

---

how we provide neutral earth on synchronising panel as per electrical standards?

0 Answers  

---

in pf lagging means current decrease by increasing voltage is correct or not ? reason ?

3 Answers  

---

How many watts required for single phase power supply?

4 Answers  

---

what happen if i change the polarity of ac when it is connected with motor

3 Answers  

---

how to calculate load if i have three phase & single phase connection from power transformer( in term of kw & kva).can i take single phase load/3 for total kw calculation

1 Answers  

---

What are the main advantages of bode plot?

0 Answers  

---

what will be the difference on output when 3phase I.M. is given a delta or star supply?

3 Answers  

---

When capacitor bank connect on line. It's draw some current but it's current not increase of main line ammeter. Why?

1 Answers   MCL, Star Wire,

---

DISCUSS THE SHAFT MOUNTED D.C. GENERATOR ,BASED ON EXCITATION SYSTEM IN ELECTRICAL SYSTRM

2 Answers  

---

we know the value of the power factor is 0.8, we know the power factor is not depends upon the load ,then why we cant design the power factor in transformer ?

1 Answers  

---