Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / venkatesh s.r
500v dc
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
what is the internal working of star delta starter
whats the application of voltage regulation? and whats the voltage regulation's device?
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
how many joint can done in HT line and what is life of the joint
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
why zero sequence impedance measurement is not applicable for single phase GT
what is the current setting for different relay protection for transformer .
how works inductive &capacitive sensors?
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
define the non synchoronism of synchoronous machine in general g or m??
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
What is the complete procedure of erection of electrical panel in industry
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
