Answer / h. k .prusty

As per IS-456/2000 Minimum Gr. for RCC is M-20, And it
varies upto M-50.

Answer / modipraveen

M10, M15, M20, M25, M30, M35, M40, M45, M50, M55, M60, M65
etc., its depend on load, span, depth of member

Answer / narendra kumar

M5 TO M65 etc.

What do you mean by TOLERANCE in steel

1 Answers  

---

How much block, cement,sand,is required for 1 sqmt of 200*200*400 block work

2 Answers   CCCL,

---

what is means of M50,M20,M15 like this please tell me ?

0 Answers  

---

How to do base isolation using ETABS software?

0 Answers  

---

what is the ideal temparature for concrete?

5 Answers   HCL,

---

Why we test compressive strength after 28 days..?

3 Answers   NM Caramoan Builders,

---

WHAT THREE SPECFIC JOB POSITIONS TO YOU TARGET FROM THE COMPANY?

0 Answers  

---

How to take measurement of plastering beam and column.

2 Answers  

---

why no deduction for steel is made in the volume of concrete?

3 Answers  

---

pls give the grads of concrete and the ratios to the same

2 Answers  

---

i want measure water capacity in 25'diameter and 7'height of water in circular storage tank in liters how?

7 Answers  

---

A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.

0 Answers  

---