what are the various types of pile foundation?
explain with introduction
Answers were Sorted based on User's Feedback
Answer / bala
1.Piles are classified on two basic
a.Based on function or use
b.Based on materials and composition
* According to (a)
-End bearing piles
- Friction piles
- Compaction piles
- Sheet pile
- Batter pile
- Under ream pile
- Fender pile.
* According to (b)
-Concrete piles
- pre cast piles.
| Is This Answer Correct ? | 10 Yes | 1 No |
Answer / hemalata d m
End bearing
Friction
Bored cast in situ
Precast
| Is This Answer Correct ? | 7 Yes | 0 No |
Answer / akshaya
Generally Pile foundation are provided where the hard strata
is at a great depth from the surface, where the surface soil
soil have poor bearing capacity.
Pile foundations are as follows...
1 end bearing pile foundation(in case of hard strata is
there but, not in greater depth.)
2 friction bearing pile(where friction material is available)
3 combined end bearing and friction bearing pile
4 tensile pile
5 compressive pile etc..
Other 2 may be..
1. pier foundation(for important structure) and 2. well
foundation(for bridge)
| Is This Answer Correct ? | 8 Yes | 2 No |
Answer / lakshitha
End bearing
Friction
Replacement- Bored
Displacement -
| Is This Answer Correct ? | 5 Yes | 1 No |
1:6 brick masonry cement and sand calculations
What are the advantages and disadvantages of using plastic and timber fenders?
How Much span required for 1 sqm of shuttering(Beam & Slab)
What is the difference between 53 grade and 43 grade cement
How to calculate the quantity of water in cement mortar eg. CM 1:3?
How much permissible bearing capacity requires for open footings(isolated) and what type pile foundatuon prefering for coastal areas?
please give the detail design for the soring and shuttering for 8.5m deep excavation in the sandy soil for 25x10 rectangular streaches
Suppose a new brick wall is being constructed,and the courses and not aligned horizontally,what negetives can it cause?
what is anchorage? Why anchoring of reinforcing bars necessary and what are the shapes ?
what is shuttering co efficient?
i have boiler of 35 tone and wanted dig out foundation is there any body to help me to carry out calculation for the foundation like
why there is no concrete mix of ratio 1:.5:1
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)