Answer / mahavir jagdev

the choke along with the starter is used to give the high voltage start to the tube light which has heating filaments at both ends to ionize the gas inside. once the tube starts glowing then only 90 volts is required to keep it going, so the starter stops the current flow into the heating filaments and the choke uses it's impedence to absorb the extra voltage from 220 volts to keep the tube light voltage to 90 volts.

how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?

0 Answers  

---

battery dis charge condition long time condtion?

1 Answers  

---

Write the analogous electrical elements in force current analogy for the elements of mechanical translational system.

0 Answers  

---

1.dg on load alarm/stop alarm... 2.dg on load. piu alarm alarm kaise chek krte hai

0 Answers   GTL,

---

what is bus duct and what is differance between bus duct and bus bar

6 Answers  

---

Is there any standard guidelines/Criteria to design NGR/NGT.?

0 Answers  

---

How can a transformer test by megger?

1 Answers   Bosch,

---

What is difference between YNyn0 and YNyn ??

0 Answers  

---

Why do not we prefer non conventional sources of energy to conventional sources?

0 Answers   Nabard,

---

explain why the secondary terminal of current transformer should not be lift open circuited.

2 Answers  

---

Sir, Please tell me that how I will calculate the efficiency of rectifier. Because input is ac and output is dc. Is it right to put two unlike signal together.

2 Answers  

---

what is magnetizing current test in power transformer

0 Answers   ABB,

---