Answer / shiva pradeep

stress is tha internal resistence offered by the object to the external force .
whereas strength is ability of the material to sustain load...

Answer / mt

Strength is the maximum stress a material can hold or withstand just before failure.

Stress is the force applied divided by the section area (stress=F/A) where F is the force and A is the Area

Answer / shah hassan

The basic difference is shown from following formula
Factor of safety= Strength/ allowable stress

Answer / aniket shyam shewate

Stress is result of loading whereas strength is the
therotical value calulated on the basis of crystal structure
and chemical composition.

For both the units and measurement systems are same.

In short we can say that while loading the material stresses
are produced and not the strength.

Answer / m,saranya

its simple

stress is the force(KN)acting in a cross sectional area
and strain is the ability to withstand that stress.

Answer / vasant channi

Stress terms

A material being loaded in a) compression, b) tension, c)
shear.Uniaxial stress is expressed by
stress=F/A
where F is the force [N] acting on an area A [m2].
But we cannot compare stress with strength.

difference between nominal mix and design mix difference between nominal size and actual size of brick,aggregate etc

1 Answers   L&T,

1)Why we can use half brick in 4inch wall and 2)why not in 9+inch brick wall

0 Answers  

what is the defination of an ideal fluid?

7 Answers   NTPC,

What is geopolymer based concrete?

0 Answers  

how to calculate Tile skirting

5 Answers   JMC Projects,

04. a. Slenderness ratio…………… 1 b. If the height of a stage is 15-0 & dia. of the prop is 5, the slenderness ratio is….… 1 c. If the height of a stage is 10-0 & dia of prop is 3, the number of bracing will be…… 1

0 Answers  

how to tie 10 legged stirrups

0 Answers   Khan,

115mm thickness brick work how to required mortar

0 Answers   J A Brothers,

which member is very strong (strength) after the cross- section area is same, pipe section or solid rod section ? no that's not my question, my question is why pipe section is strong ?

2 Answers  

what is the proportion of M200 &M300 grade concrete

1 Answers   Karrm Infrastructure,

how much M-25 steel reinforcement per cubic meter in commercial building as per IS code

2 Answers   Shyam Indus Power,

What is a MIS report?

1 Answers   NCC,