Answer / y . rama devi

The difference between direct and indirect loading is that intermediateris (act as controllable switch) that can turn power to a load

what objective books are good for preparing for PSU's?

3 Answers   NTPC,

---

what is the difference between isolation and insolation ? please explain in detail with example.

5 Answers   ABB,

---

What are the main significances of root locus?

0 Answers  

---

Is pure capacitor load and pure inductor load is an linear load? pls justify

2 Answers  

---

I have 11KV/415V power distribution transformer. I have found unbalance current in LT (415V) side. Also observed that unbalance voltage (3V) at LV side due to HV side unbalance voltage. What should I check for this? Also, the same LV side load can run in balance on captive power.

1 Answers  

---

When we giving the 3 phase supply to ups system how to coming netural?

0 Answers   Juniper Networks, Tata Motors,

---

why ct output is in 5A?

3 Answers  

---

Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?

0 Answers  

---

In case of 11kV dual delta bank what are the recommended protections with specific CT / VT requirements? The capacitor bank is to be connected to the main 11kV switchgear from where the H.V.Motors and auxiliary 440V loads.

1 Answers  

---

how to find the resistance

3 Answers   Saint Gobain,

---

Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.

0 Answers   NCC,

---

how many earthing is required for sever room?

4 Answers  

---