Answer / sanjay

REYNOLD NUMBER : It means rate of flow.
Re = p VD/u
Where
Re = Reynolds Number, v = Velocity of flow in m/s, d =
diameter of pipe in m, p = density of fluid in Kg / M³,, u
= Viscosity of fluid.
Turbulent or laminar flow is determined by the
dimensionless Reynolds Number.
The Reynolds number is important in analyzing any type of
flow when there is substantial velocity gradient (i.e.,
shear.) It indicates the relative significance of the
viscous effect compared to the inertia effect. The Reynolds
number is proportional to inertial force divided by viscous
force.
• laminar when Re < 2300
• transient when 2300 < Re < 4000
• turbulent when 4000 < Re

Answer / jothi

In addition to the above,
Laminar flow shows a parabolic flow while a Turbulent flow
shows an irregular flow. This can be seen when you put a
piece of floating material like paper, small wood etc on
the flowing liquid.
But for Transient or the Partial flow, its normally based
on the assumptions, even if we know the Reynolds number,
which includes the type of Liquid, its viscosity, and
impurities too.

Answer / monu

row d v/ myu

where myu is viscosity d = dnsity and v= velocity that
eqation gives reynolds number.......moreover if reynolds
number is high .....fluid is a good one with low
conductivity and low viscosity

in current transmitter why we use 4-20ma ???

2 Answers   IMCO, IOCL,

---

Hi Friends , i need one urgent help , i am preparing for M.tech entrance examination , i need some obejective questions related to instrumentation field. where can i get those ? can anyone help me pls ?

1 Answers  

---

Why do we use 24V DC supply in instrumentation? What are its merits and demerits??

1 Answers   JSW, MJPRU,

---

Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?

1 Answers  

---

What is mean by AC voltage and DC voltage

2 Answers  

---

what is the meaning of potential free contact. difference between dry and wet contact?

6 Answers   GAIL,

---

In your own words, would you expect an ultrasonic level device to work better in a pressure vessel with a high pressure or a strong vacuum, and why?

1 Answers  

---

What is rated capacity in Control valve

3 Answers  

---

what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .

1 Answers  

---

how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?

1 Answers   SEWA, Sharjah Electricity and Water Authority SEWA,

---

Is an analogue only transmitter as accurate as a smart transmitter?

2 Answers   SCA,

---

Give 2 application of quartz crystal used for process parameter measurement.

1 Answers   ADMA OPCO,

---