Answer / antaratara ghosh

Line PT is connected in the incomer (line) to detect the
voltage of the incomer whereas bus PT is connected in the
bus, 1 before the bus coupler and another after bus
coupler, to detect voltage in the bus.

The main purpose of both of them is to sense the voltage so
that the breaker can get enough information to operate..

Answer / maloy

line pt is connected in incomer where the bus pt is connectd in the main bus bar though both funtioning the same for measurement & protection

Answer / muhammad abid ali shah

Line PT is used to measured the voltage and also used for voltage protection means that under voltage or over voltage and the bus PT is used for metering and measure the voltage of bus bar voltage.

what is difference between sub-station and switch yard.

16 Answers   Bhel, Ravate,

---

which of the following loss varies with the load a)hystresis loss b)eddy current loss c)copper loss d)core loss

2 Answers  

---

When charging a 20 MVA , 33kV/6.6kV transformer through regulated (0-6.6 kV or 0-33 kV) source on no load , what will be the maximum current drawn by transformer from source and what sould be the source capacity.

5 Answers   TATA,

---

What is the effect of impedance on the heat losses in case of AC system??? Does heat losses really depends on the impedance or depends only on resistive component only..??

4 Answers  

---

Ash AAAC conductor is used for which KV lines

1 Answers  

---

if installing the transformer why put the sprit the stone ?

1 Answers  

---

what is the advantage of NiCd battery over Lead acid battery?

2 Answers   BARC,

---

what is breathing?

0 Answers   PWD,

---

why neutral used in three phase motor connection?

3 Answers   BEL,

---

What is the suitable rating of MCB used for 1.5 Ton A.C & why?

4 Answers  

---

how to select cable size for three phase?

1 Answers  

---

PLZ EXPLAIN CORONA,SKIN,BIRD PALE,SPAN,SAG Effects of power cable.

0 Answers  

---