Why star pointed terminal have no current? how?
Answers were Sorted based on User's Feedback
Answer / rafi
The star point will have the current equal to the vector
sum of all the threee currents flowing in each winding.
since, the currents in each of the windings will differ
with a phase diff of 120 degress the vector sum will be
zero. provided, the currents in each phase should be equal.
| Is This Answer Correct ? | 13 Yes | 1 No |
Answer / aung myo myint
yes, by the wave forms all plus and minus are equal.So, you
can get zero. This is the end of electricity point.
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / jayant mistri
At the star point vector sum of current is zero. If vector sum of current is not zero, deference of current will flow through star point.
| Is This Answer Correct ? | 0 Yes | 0 No |
how was your last weekend.
what is transistors comprised of?
Which type of a.c motor is used in the fan (ceiling fan, exhaust fan, pedestal fan, bracket fan etc) which are find in the houses ?
in transmission line, if the load is suddenly increased at the receiving end of the system the phase shift will (a)decrease (b)becomems zero (c)increase (d)not be affected
suppose if oil in transformer is not used than what constructional change you will do,for insulation and cooling?
why is a avtomatic voltage regulator used for?
What is the List of Equipments, Instruments, Components required in Transmission of electricity from 1 substation to other substation(The equipments required in substation too)? What are the differnt IS standrds used for above equipments in Industry?
How to conduct Magnetic Balance Test, Measurement of Excitation Current (both on HV- and LV-side) and vector group on a 1000 KVA distribution transformer. There is a neutral on HV side.
what are tpes of insulaors& its uses
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
What is the disadvantage in proportional controller?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)