Answer / rajkumar

Shield wire is to eliminate the noise pickup in the signal
wire due to magnetic interference from the near by
source
Panel or JB side shield to be earthed but Instrument side
no need to do earth (cut the shield and tape).

Why we using 250ohm resistance during lab calibration and why not using in field in one plz define deeply???

1 Answers   Cisco,

---

How to convertion 100 m3/hr to mmH2O or to Kg/cm2?

0 Answers  

---

pl give the guidance for DUBAL written test

1 Answers  

---

how to calculate signal cable sizing? and multipair cable sizing??explain in brief?

1 Answers  

---

in control valve is constructed as per API 6D or API 6A, then which standard is used for fire testing of valve?.

1 Answers  

---

If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?

1 Answers   QAFCO,

---

How to get Cv of control valve having following parameter ,i.e inlet pressure 4.5kg/cm2 outlet pressure 1 kg/cm2 specific gravity 0.808

3 Answers  

---

a pressure transmitter with a range of 0 to 2500kpag has a specified accuracy of 0.5 % of span.It is to be calibrated using a comparison gauge to have an accuracy of 0.1% of span.The comparison gauge has a range of 0 to 3000kpag What is the accuracy ratio? is this ratio acceptable?

1 Answers  

---

how to calibrate motorized operated valve?

1 Answers   Bilt, Jubilant, SRF,

---

What is pressure,What is temperature,What is flow,What is level

4 Answers   Keltech, Petrofac,

---

How to consider the flow directions for control valve (Globe) Is the there any easy understanding in order to select the flow directions?

3 Answers  

---

How much flow is passing through 6 inch line? There are no gauge, no any transmitters in line.

3 Answers  

---