Answer / saravanakumar

INSTALATION MEANS ERECT THE MACHINERY AS PER THE GIVEN
DRAWING WITH SAFTY AND WITHOUT ANY DAMAGE OF THE MACHINERY.

COMMISSIONING MEANS THE SAME MACHINERY IS HANDOVER TO THE
CUSTOMER WITH GOOD WORKING CONDITION

Answer / kanth

installation means equipment keep in a right place in a
right manner without damage(ex
pannels,motors,pipeline,whatever it is)
and in commissioning we have to start the equipment and
give to the coustmer without any damage,it include risk and
troubleshooting

Answer / sudhakar reddy

Installation means just like access control installation
support readers and controllers installation that is called
installation commonissonig all control cabels laying for
readers and controllers thati is commonissonig

why we use stones or rock pieces in transformer area?

10 Answers  

---

Why all transmission lines are AC, not DC line?

4 Answers  

---

What is domestic transformer? Draw the connection of domestic transformer.

0 Answers  

---

what is floating charger and boosting charger?

4 Answers  

---

If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive

0 Answers  

---

If UG power cable both ends are to be earthed or what? If not why?

0 Answers  

---

Relay setting for earth fault of reciprocating and centrifugal compressor motor feeder.Setting will be different or same?

1 Answers   Reliance,

---

What is Primary and Secondary Injection Test of CT and Relay.

2 Answers  

---

what is the use of starter in tube light?and what it contains

12 Answers   L&T, RRB,

---

How Can You Relate Power Engineering With Electrical Engineering?

0 Answers   ABB,

---

WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION

0 Answers  

---

diffrence between windings of high tension side and low tension side of transformer

1 Answers  

---