how can we change the phase angle b/w two phase?

Question Posted / deepak24

2 Answers
5265 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

how can we change the phase angle b/w two phase?..

Answer / ather alam

Please identify what is your source.
If you are using Freja XX series. you can change the phase angle between both voltage and current.

Is This Answer Correct ?

2 Yes

2 No

how can we change the phase angle b/w two phase?..

Answer / sujal

If it is a D.C souce Then by changing the possitive and
negetive terminal u can change..
And for A.C its not possible.

Is This Answer Correct ?

0 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

Why the output of generator varies eventhough the shaft speed is constant in thermal power plant?

5 Answers

what is the difference between isolator and circuit breaker

3 Answers

What are the types of Transformer? Name them.

9 Answers Bhel, HSL, NTPC,

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers

Please brief working principle & construction of permanent magnet AC Servo motor

0 Answers DRJ ARDE,

What is Biased Generator Differential Relay?

2 Answers

What is resistance reading of earth copper rod with grid and without grid?

0 Answers

IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?

0 Answers

what is the use of CAPACITOR in CFL lamp?

6 Answers Areva, Autopal,

Why annealing is done on transformer core manufacturing process?

1 Answers ISRO,

what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.

0 Answers Ahsanullah University of Science and Technology,

what is ELCB?

10 Answers Wipro,

For more Electrical Engineering Interview Questions Click Here