Answer / eng_entropy

For tension tower:-
It located between every three or four suspension tower to
pull the conductors which are re-tied in tension tower
insulators.

For suspension tower:-
The conductors just hung-up on it's insulators and not to
re-tied on it (I mean it just pass through a ring at the
end of the insulator).

Answer / pankaj singh khetwal

when routing of tower deviates an angle more than 2 degrees
then tower at point of deviation faces tension due to pull
in conductors and hence known as tension tower where as
tower with angle is less than 2 degrees line deviation is
known as suspension tower

Answer / vaidy

The tension tower carries both horizontal and vertical load.
The supporting tower carries only vertical loads.

Answer / malik

tension tower = (Road crossing,deviation in transmission
line )wr conductor is tied up firmly by means of tension
insulator
suspension tower = to minimize the sag the conductor s just
tied up with suspension insulators

Answer / ajit singh

firstly define these two towers

Answer / dipanku goswami

Suspension tower is used where the angle of deviation of the TL route is 0-2 degrees. Here the conductor is simply suspended on the insulators.
where as tension towers (B,C,D type) are used where angle of deviationof the TL route vary from 2-60 degrees.Strain type insulators are usedc in this case.

Answer / gunasekaran

if u use insulator as a suspension type that is suspension
tower.use as a strain type that is tension tower. in strin
type sag is less than suspension.

Answer / simhachalam

Tension is above 90kn

Suspension is below 90kn



MS CHALAM(GOLDSTONE)

tell me the various standerd of CT ratio

1 Answers   ICA,

orifice sizing how done, checking & selection

0 Answers  

How to conduct the Magnetic Balance test on Power Transformer?

0 Answers  

how the find ct mf and mf roll in metering

1 Answers  

1500Ah VRLA battery,if its weight is designed 125kg during maufacturing its weight is reduced to 85kgs,What will be impact on AH capacity,life & economy?

0 Answers   Bajaj,

In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above

0 Answers  

what is meant by excitation current & armature current ? where its produce & how we can calculate ?

0 Answers  

how to find out capacitor range?

2 Answers  

What is YNyn Transformer? and what are the other types in this?

3 Answers  

i have a motor 55kw how u will calculate cable specification for this motor

1 Answers  

Natural frequency in the control system represents nature of a. Transient response b. Oscillations c. Overshoot d. Speed of responce

1 Answers  

What is PIR (pre inserting resistance) in 400kv EHV SF6 BREAKER? Why it use?

1 Answers   Adani,