Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between tension tower and suspension
tower?
- 8 Answers
- 44826 Views
- I also Faced
- E-Mail Answers
Answer Posted / eng_entropy
For tension tower:-
It located between every three or four suspension tower to
pull the conductors which are re-tied in tension tower
insulators.
For suspension tower:-
The conductors just hung-up on it's insulators and not to
re-tied on it (I mean it just pass through a ring at the
end of the insulator).
| Is This Answer Correct ? | 38 Yes | 12 No |
Post New Answer View All Answers
What test must you do before powering up a circuit that you have been working on?
Explain the experiment on ward leonard method of a speed control on a dc shunt motor with an suitable circuit diagram.
On what cycle does thermal power plant operate?
What is touch potential and step potential?
What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
what is the voltage between earth to neutral in lift.
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
give single line diagram of D.G distribution form alternator to main L.T panel?
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
is oil viscosity affect on motor current?
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
sir please tel me how calucalte kwh if home taken load 30ams how maney kwh taken per day.and 3phase motor 5hp per hars how maney load teken and how mach kwh and forward me to electrical table for calicalte kwh and kvr and kvah
