Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between tension tower and suspension
tower?
- 8 Answers
- 44337 Views
- I also Faced
- E-Mail Answers
Answer Posted / dipanku goswami
Suspension tower is used where the angle of deviation of the TL route is 0-2 degrees. Here the conductor is simply suspended on the insulators.
where as tension towers (B,C,D type) are used where angle of deviationof the TL route vary from 2-60 degrees.Strain type insulators are usedc in this case.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
Hello sir i m student of gtu .what is idp.
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
What type of core material is used for metering C.T and protection C.T???
Which do you think is the most significant cause of energy loss in a factory?
what are the possible reaons & remedies if resistance of NGR getting heat up
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
What is meant by stator?
where was current transformer protection units used and why??
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
whit is 33kv power 300*300 cable full current with formula
What are approaches to tackle sedimentation problem of reservoir?
