What should be the lap length in raft if height of raft is 0.800mm ...it couldn't b 50D or 40D...we just have to join upper and bottom reinforced...is there any formula for determine it...

0 Answers   SIPL,

---

Design a shear wall of length 4.20 m and thickness of 250mm subjected to the following forces.Assume Fck = 25Mpa and Fy = 415Mpa and the wall is a high wall with central part 3440mm x 250mm and two 380mm x 760mm strong bands at each end with following loading. S.No.       Loading        Axial force      Moment     Shear 1               DL+LL          1950              600            20 2           Seismic load       250              4800          700

0 Answers   L&T,

---

What are the composition of a landfill?

0 Answers  

---

Hello sir,I am preparing for GET,Jindal steel & power limited.So can u plz send me few back papers including technical & aptitude.

2 Answers   Jindal,

---

which software is better for design and analysis of buildings (stadd pro ) or (Etabs)

0 Answers   CCCL,

---

what do you know lean concrete

1 Answers   Adarsh Group,

---

how to determine pile length and diameter of pile is there any thumb rule?

2 Answers   Al Habib,

---

How did street originate in the plumbing term street ell?

0 Answers  

---

What is the proportion of M30 to M80and which construction these are used

3 Answers   Unicel,

---

Why should you show Client/Engineer activities clearly on the project plan?

0 Answers  

---

what will be the cement and sand needed for 1sqm plastering ? for ratio 1:6 and 10mm thick

4 Answers   HLL,

---

CAN WORK WELL UNDER DEAD LINES OR PRESSURE?

0 Answers  

---