What is ramp signal?

0 Answers  

---

If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.

0 Answers   MEIL,

---

How can step up and step down process in power transformer

1 Answers   MSETCL Maharashtra State Electricity Transmission Co Ltd,

---

what is the advantage and disadvantage of billing in kwh and kvah by electricity board .

6 Answers   Nespak, NTPC,

---

Why the ceiling fan rotates in clockwise direction and table fan rotates in anticlockwise direction.

3 Answers   Kirloskar, MPF, Wipro,

---

how we select HRC FUSE ?

1 Answers   AXA,

---

Why only plate(copper) Earth pit given for neutral earthing? why not pipe(G.I) Earth pit?

1 Answers  

---

what is armature reaction?explain in simple words?and what is its infleunce on dc motor

16 Answers  

---

Briefly describe three methods that are usually used by electricity suppliers to control voltage levels?

0 Answers  

---

what is the load amp of a 2 hp single phase motor?

6 Answers  

---

what is the pressure in side transformer under normal condition?

1 Answers  

---

why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)

0 Answers  

---