Interested to Buy Any Domain ? << Click Here >> for more details...
why do we need to use 3c+3e cable, normally i select only
3c+e cable and i think it is enough. pls explain the
usefull of 3e cable ( in this project the earthing system
is well done)
- 0 Answers
- 2476 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
According to general circuit diagram of 1-Phase t/f , why the primary is not get short circuited ,even though the supply terminals both are directly connected through primary winding?
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
from which formula we select a capacitor rating?
where we use the SFU & FSU?
what will be the breaking capacity of MCCB of 1000kVA (6% Impedence) transformer? Voltage being 415V, Power Factor 0.8.
How to calculate the current capacity of the 3C / 1C Al/Cu power cable???
what would happen if u assume to insulate all the overhead lines and no insulators....??do you think it to b an advantag or a disadvantage??justify.
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
why the single phse machine can not run by the three phase supply.
Determine the BTU size of an aircon for 20 sq metre room
what is buffer resistance starter.?.What is the working principle and where it is used..?
How much current does a motor take in no load condition?
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
