Answer / jodhani mukesh

speed of servo motor is more as compered to induction.

Answer / mukesh rana

Servo motor has a closed loop negative feedback system
whereas the general induction motor has feedback mechanisms
(in inbuilt encoder).

Read more:
http://www.differencebetween.com/difference-between-servo-motor-and-vs-induction-motor/#ixzz2fdZtbYhb

Answer / asanya

Main different between these two motor in induction motor we power source directly but in servo motor we pulse rating. That why its give more accuracy than induction motor

Answer / mojahid

Servo motor provides high torque and easy to give position.this motor eaisly stop as we see in modern lathe machine while induction motor has less torque but high inertia.it stop at slow rate as we see in centre or conventional lathe.

Answer / krishan singh

Servo motor high torque

Answer / rb

torque can be controlled by servo motor

Answer / parvez akhtar

main diff. is that servo motor rotate in both direction i.e
clockwise and anticlockwise But induction motor rotates in
one direction i.e either in clockwise or anticlockwise

Answer / krishnan

if we give supply to induction motor then it start to run
continously but in servo motor it rotates with the ref.
given by its sourse for eg. tankers used in army

Answer / rishi

servo motor has two rotation which is not possible in
inuction motor

Answer / geeparthi

speed constant in servo motor

state the working principle of incondenscent tube?

0 Answers  

What are the types of circuit breakers ?

6 Answers   Genco, Super Max,

how to identyfy cable sizes?

4 Answers   IAF, Mylan,

What are the types of class b amplifier?

0 Answers  

why dc moter are not earthed ????

2 Answers  

single phase 230v three phase voltage 415volt why we aren't used line voltage 690v?

7 Answers   Citec,

when the flux enters into saturation mode then what will be the secondary voltage of the normal t/f?....high or low ? explain ...how?

1 Answers  

We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible

0 Answers  

what is parellel power factor correction?

2 Answers   HCL,

Draw SLD for a panel has 500A Bus Bar rating, with 4 outgoing, each is 80 A (load current), showing the transformer and capacitor bank rating.

0 Answers   FEWA,

Why neutral is not used in three phases dol starter

0 Answers  

3phase motor 400v (induction) A.C 4kw company design 1400rpm but our requirement 2000rpm possible? attached any instrument. reply fast! contact 03343262442

3 Answers