how we calculate full load current of A.C & D.C Motors?



how we calculate full load current of A.C & D.C Motors?..

Answer / k.prakashchandra

AC HP x 750/3x ph voltage x 0.8,DC -HP x 750 / Vx0.9

Is This Answer Correct ?    3 Yes 15 No

Post New Answer

More Electrical Engineering Interview Questions

1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?

0 Answers  


In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?

0 Answers  


why wound rotor is star-connected?

4 Answers  


how we can do the insulation on secondary of ct explain and so that tan delta will within limit

0 Answers  


if sf6 gas low in gis what will happen

0 Answers  






what is an invertor A.C.?

1 Answers   Ami Tech, Shubham,


what ll happen if neutral is not shorted with phases while doing transformer short circuit test & what ll happen if neutral is connected to ground?

1 Answers  


As per which Indian Standard induction motors are manufactured?

2 Answers  


How we can make sure cable size of LT cable without any parameter.

2 Answers   Paradip Port, Siemens,


why 15 kw motor winding resistance is low then 5 kw motor winding resistance?

0 Answers   Baosteel,


two bolbs of 100w and 40w respectively connected in series across a 230v supply.which bolb will glow bright and why?

16 Answers   DRDO, PSPCL, Siemens,


What is meant by line losses, how do you prevent the losses?

3 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)