If the characteristic Impedance is equal to load Impedance
then……
a) voltage will be increased b) power transmission is
zero c) …… d) max. power is transmission to load
Answers were Sorted based on User's Feedback
hello every one, what is the difference between the Kvar and farads, Rating on Power capacitor is for eg: x kvar, and normal capacitor is eg: x farads. what is the relation between these two?
what is an oscillator?
How turns ratio test is done in three phase transformers?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage.
Hydro P.P. run @ 600 rpm,8pole, Nucler P.P @ 1500rpm 4 pole , ThermlP.P @ 3000 rpm 2 pole.Why this diffrence??? when we can generate electricity @ 600 rpm then Why we had incresed speed in NPP & TPP???
how generator generates electricity?
what is a universal motor? how it works?
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
Railway Basic electrical engg technical question with answer
What are the typical values of characteristic impedences of overhead line and underground cabel? Why there is so much variation?
what is ignition?
How does a transformer contribute towards the widespread popularity of ac system over dc?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)