Dear sir,
I am working in wind mill division , pls explain
Pls explain in details with formula
My question is
Wind speed 3.5 M/s Gen RPM
is 1500 ( 25 K/w Production )
Wind speed 12 M/s Gen RPM
is 1500 ( 220 K/w Production )
Why in 3.5 m/s generation was low , why in 12 m/s
generation was high ,
Pls dont explain wind force or wind density , that one
already i know
For the above question RPM was same why the KW was
different
Answer : 1. Its depends on the density ( Force ) of the air
Sir ,
Pls explain wit Formula sir
The gen speed has to be the same to maintain the
frequency.At higher wind speed wind-mill receives more power
from wind and hence the higher output.
| Is This Answer Correct ? | 1 Yes | 2 No |
On Which Pressure PRV is operated.
How to calculate cable size by using load.?? Any formula...
How to determine earth fault level to set relay for a normal distribution system of 11 kV , 100 A load????????
what is the aircraft voltage and frequency standard ?
what was the function of the auxillary relay?
I want to know if it is possible to use Variable Frequency Drive to reduce the current required for starting a motor?
what is the cause of voltage dipp or swell in the transmission lines?
Which motor has more efficiency ;Synchoronous or Induction motor ?
What is the effect of pd controller on system performance?
what is meant by Back emf ?where its occur ?
What is the Ramping rate of Generator. What mena Ramping rate
why is the number of turns different in current and potential coils of wattmeter..?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)