Answer / santosh

A stepper motor (or step motor) is a brushless, synchronous
electric motor that can divide a full rotation into a large
number of steps

Answer / shinyvikram ganji

it rotates in uniform steps either in clockwise or anti
clock wise direction.

Answer / m.rama lakshmi

Steper motot is like DC motor. but it can run by controlled
input pulses(step by step rotation).

this is used in the field of robatics.

micro controller---->driver circuit--->stepper motor

Answer / vishvesh

stepper motor is the electrical machine which act upon
input pulse applied to it. it is one type of sychronous
motor which runs in steps in either direction instead of
running in complete cycle.
so, in automation parts it is used.

Answer / sreeram

IT CAN B COTROL AT ANY REQUIRED STEP....THAT IS IT CAN
ROTATE AT ANY REQUIRED ANGLE

Answer / percy

STEPPER MOTORS ARE HIGHLY PRECISE THERFORE THEY ARE USED IN
PRINTERS , TYPEWRITERS , X-Y Plotter/Recorders

Answer / ponnarasan.m

stepper motor is a one type of dc motor.this motor may also
called as "stepping motor".a pulses gives to a motor
input.so it works at desired speed.
uses:robotics,CNC lathe,and speed control.

Answer / rajendra sadaphale

stper motor is dc motor operated in stapes it is contorled
by microprocesser use in cnc m/c

Answer / sunitsaini@interview.com

stepper motor is a d.c. motor which works in digital manner
and interfasing is possible in this motor with microprocessor

what is the different between bus section and bus coupler

1 Answers  

Why insulation layer of a High Voltage cable is more than a current carrying cable?

3 Answers  

In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?

0 Answers  

what is the relevance of knee point voltage in protection and metering grade CT ? and basically what is knee point voltage ?

2 Answers  

IN MY INDUSTRIES 125 HP MOTOR USED FOR THAT ONLOAD AMPS UP TO 280 SO CAN I USE ONE LOWER KVA DG SET WITH STEP UP TRANSFORMERS THAT MEANS WITH LOW POWER INPUT TO GET CONSTANT HIGH POWER OUTPUT EG:125KVA DG SET = 250 KVA STEP UP TRANSFORMERS

1 Answers  

Why one side of secondary of transformer is earthed, to supply single conductor of electric traction system?

1 Answers  

Which standard we are following earthing resistance test

0 Answers  

ELCP USE IN 3 PHASE SUBMERSIBLE PUMP? THEN USE 3 POLE 0R 4 POLE?

4 Answers  

What is the winding resistsnce need to be in a 1000kva, 11kv/415v transformer, between ht winding to lt winding, ht winding to earth, lt winding to earth.?

1 Answers   Trident,

what is the cable capacity of any load wise .

2 Answers  

say a transformer is designed for 33/11kv step down with ratio 0.33 for load 1 mva. if am giving 11kv as a input that same transformer what will happen to its o/p voltage. and whether it can be operated for 500kva

4 Answers  

Why the size of transformer decreases if we increases the frequency?

5 Answers   Graphics Engineering,