Answer Posted / mohammad farman khan
Because of reducing resistance , other touch and step
voltage to be reduce, once fault happens then get maximum
ways to go into ground
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
What is the height of DA, DAL, DB, DC & DDE tower?
What are the commonly used schemes for the bus zone protection?
What is the effect of positive feedback on stability of the system?
how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc
What is limitedly stable system?
How to measure size of cable on a given load
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
how to calculate transformer turn primary & secondary side 11kv to 420v
What is shunt voltage and u v voltage witch one best
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?
How shall i select the value of capacitor or inductor in a system?