Answer / naveen

it depends up on the load connected and if same load is
conneted then the current flow in single phase is root
three times more.

Answer / abhishek0015

It depends upon connected load. As per formula,
P= V*I*(cos phi)-- for 230v supply and
P= sqrt3*V*I*(cosphi)-- for 415v supply
So it means in 230v single phase supply takes almost 3
times more current than 415v three phase supply.

Answer / arpit

it will be the same since 230volt ac and 415 volt ac are
star connected, in star VL=1.732* vph, and current is same.

Answer / srujanya,rec

By taking the OHM's Law i.e. V=IR. here we consider R is
constant then V is directly proportional to I. it means If
Voltage increases then current also Increases. in 230V ac
supply gives 23A. In 415V ac 41.5A flows(R=10 ohms)

Answer / prabhu

current is load connected in the supply.
If same amount of load was connected in single phase and
also in three phase ,the cuurent taken by single phase is
of 3 times more than the three pahse.

Answer / samit sinha

As mentioned by Srujanya, V=IR is wrong it should be I =
V/R because current is proportional to Coltage and not
voltage is proportional to current. When the potential
difference occurs then only current flows - Samit

What is the armature mmf in a D.C machine?

0 Answers   HPCL,

What is DPR relay, And what for??

2 Answers   Engro,

what is 'A' Check & 'B' Check ?

2 Answers  

any calculation method for decide cable size for current?

1 Answers  

Tell me about ur past electrical maintanence job

0 Answers   Apollo Power, Solar,

HOW TO CALCULATE THE DOMESTIC POWER FACTOR?

3 Answers  

why does make gain margin and phase margin on same plot.?

0 Answers  

1.After synchronising the alternator to the grid,how we r delivering power to the grid?if the i/p increases does the speed hence frequency increases? 2.y the power factor is changing when exitation changes?what is the relation with p.f and flux?

4 Answers   BSNL,

What is the AVR in DG & its functios

2 Answers   Godrej,

what are FM 200 systems? why it is useful for electrical systems ?

3 Answers  

what is die electric strnth of transformer ?

0 Answers  

Post possible questions for Power Factor Panel FAT / SAT

0 Answers