Answer / aatif alvi

Whenever we see in oscilloscope. the dc value .e.g if 3V
will become the axix and the Ac voltage will move to that
point .

whatever the dc voltage will be . AC will follow the Dc line.

Answer / vijay kumar surla

The AC voltage is the voltage between the phase and
the neutral. If the neutral is mixed with DC then you can
observe a shift in the AC voltage with the specified dc
line voltage as reference axis. But if the phase is mixed with the DC line then there will short ckt. And the fault current flow through the DC and AC lines.

Answer / murali

When the AC and Dc is mixed, there will be a shift. if the
+Dc is mixed, the ac will be shifted upward and -DC will
shift the AC downward. this can be seen using oscilloscope.
the shift will be depending on the magnitude of DC.

Answer / surendra

This is similar to phenomenon called CLAMPING the ac signal's magnitude is increased by dc magnitude,i.e it shifts above reference axis. . .

post your comments to kvv.surendra@gmail.com

Answer / pradeep

when ac and dc is mixed then spark may be occur in your
meter that cause fire..be awarte dont try this..
pradeep ojha(escorts)

Answer / md. zakir hosen

We know that ac current also contain dc part or parameter.
but in practical case when any dc supply mixed with an ac
supply then a abnormal situation will occur and system will
be unstable.but small quantity of dc may carry or used with
ac system.

thanking u
z_hosen@yahoo.com

Answer / vishvesh

if both AC and DC supply will mixed then the resultant
supply will become DC with pusating nature depend upon the
magnitude of the both the supplies.

Answer / sukhvinder

fault in system will occur.

Answer / aniruddh

if wew making a dc current mixed the current is in pulse
form &they are symetrical.

What is the calculating formula for HT and LT amps in a transformer.

22 Answers   Cipla, K-Electric,

when two gen set runing in parallel but thay have diffrent pole pitch, then what will be happan

0 Answers  

hoe to select the cable size in sq mm for certain load?

5 Answers   TCS,

why capacitor is not discharged phase to body

1 Answers  

what do you mean by earth fault in transformer?

2 Answers   L&T, UPL,

how to converate kva to kw ?

4 Answers  

I've descovered that when the earth wire in a domestic electrical installation is not connected back to the board (ground) a voltage of between 9-24v is is found to be present in the earth wire. When connected at the board there is no voltage - is this normal and why does it happen?

3 Answers  

Why the steam turbines are run at high speed where as the hydro turbines are run at low speed?

1 Answers  

List the materials required for Pipe Earthing.

2 Answers  

What is the type of feedback used in an op- amp schmitt trigger?

1 Answers  

which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor

1 Answers  

How many types of Transformer testing..

1 Answers