What is LT? And specify the range of voltage?
Answers were Sorted based on User's Feedback
Answer / mohd. karim
LT - Low Tension (Low Voltage)
It depend on our reference voltage...It means our system is
440KV than we say 33KV & 11KV &3.3KV are LT for our System.
If our system is based on 11KV (Higest Voltage of System)
then 3.3KV & 415V is LT for based voltage.
Is This Answer Correct ? | 31 Yes | 9 No |
Answer / naresh
LT refers Low Tension. Its range is as follows....
1) For Single Phase it is 240V and
2) For Three Phase it is 415V as per Indian standards.
Is This Answer Correct ? | 22 Yes | 1 No |
Answer / amit upadhyay dscl
LT is low tension side,and the specify range is 415v
Is This Answer Correct ? | 25 Yes | 8 No |
Answer / avnish sharma
Upto 650 V the Power Supply is considered LT ( Low Tension), but 650 V is not a general utility voltage.
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / ashish jain
any voltage level below 1 KV is called LT(low tension). in
industry generally it 415 V, mining it is 650 V.
Is This Answer Correct ? | 7 Yes | 1 No |
Answer / hasan mehdi
LT is Low Tension, and specify the range of voltage 440V.
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / srinivas
Up to 650 V ,AC power supply is called L.T power, as per IE rules.
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / veresh g
# 1 LT is low tension side,and the specify range is 415v
Is This Answer Correct ? | 8 Yes | 6 No |
Answer / k.prabhakar reddy
LT means Low tension Voltage.the range of LT Voltage is less
than 3.3KV and above 3.3KV is High tension Voltage
Is This Answer Correct ? | 0 Yes | 1 No |
low tension power supply . the rete of voltage is 230V
according to india standerd
Is This Answer Correct ? | 8 Yes | 16 No |
How to model two generators into a single generator ? Eg. two generators connected to a bus, would like to model it as a single generator connected to a bus.
What is the full form of GSL wire
What is thermal overload relay
why the transformer ratings in kva or mva?
Can VFD step up to 60 Hz if it is designed to receive 50 Hz input?
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
At what speed an electric car can run with 2 HP motor of weighing 400 kg?
What is the basic principle of operation of alternators/dc generators?
Generally transformers has delta primary and star secondary. But in some transformer i saw Star primary and delta secondary. what is the reason for chosing like this?
how to calculate KA rating of C.B?explain with Formula.
what is the formula for calculating of dielectric strength of transformer oil.
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection