What is LT? And specify the range of voltage?
Answer Posted / mohd. karim
LT - Low Tension (Low Voltage)
It depend on our reference voltage...It means our system is
440KV than we say 33KV & 11KV &3.3KV are LT for our System.
If our system is based on 11KV (Higest Voltage of System)
then 3.3KV & 415V is LT for based voltage.
Is This Answer Correct ? | 31 Yes | 9 No |
Post New Answer View All Answers
I am doing apprenticeship training at HT switch yard in NLC. How can i get electrical c license. ??? What r the rules for getting it as an apprentice? ??
what is PWM in IGBT and how it works for drive.?
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
Describe the colour rendering properties of i) tungsten filament lamps ii) tubular fluorescent lamp
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
how to design coil turns ?
Can RCD's used to protect the VVVF drive if not why.
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
HOW WE CHOOSE EARTH'S POTENTIAL AS ZERO V?
what is the function of impulse relay
power transmission pole used one support , that only for support or earthing
battery capacity use of made?
what is meant by flywheel and its role in retardation test
What is the fault or needs to be done when frequency in ac drives is not changing?