during installation time of transformer and alternator
which points we have to observed?
No Answer is Posted For this Question
Be the First to Post Answer
What is the full form of SON-T lamp?
What are m circles?
The capacitive reactance of a capacitor of 1/(2(PI)) F at 10^3 H is
How can the direction of a three phase induction motor be reserved
Can i use to 3 phase 4 wire energy meter inplace of 3 phase 3 wire energy meter ?
which course is maximum demand in industry and give me the list of best courses for electrical engineers
how to calculate the settings for shaft ct protn in hydro generators
What is primary and backup protection?
We say that if voltage in a power system is increased,for a constant power the current will decrease (by P=VI). isn't this in disagreement with the ohms law(I propotional V;resistant const.).Since the resistance of transmission lines remains constant,shouldn't inc in voltage cause inc in current across the transmission line? I have read many articles across the net but still couldn't this figure this out. :( Guyz plz assist me with dis..:)..
Why does inductor is connected to dc supply? or what is the role of an inductor when connected to DC source?
From stability point of view,What(higher/lower) should be the value of inertia constant of rotating machines?
what are the different type of transformers available in markets???
6 Answers Atomic Energy Commission,
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)