During the troubleshooting of an inoperative shunt
generator, you found the voltage to be 2+ volts; what is
known from this. Is it
(1). odds are the armature is good
(2). odds are there is no field current flowing in field
windings
(3). odds are the armature is bad
(4). both 1 & 2 are correct
(5). both 2 & 3 are correct
Answers were Sorted based on User's Feedback
Answer / saurabh sarkar
odds are there is no field current flowing in field
windings
| Is This Answer Correct ? | 5 Yes | 1 No |
Answer / vidhy@....
both 2 and 3 are correct........
An armature mean the pole piece of a permanent
magnet or electromagnet, or the moving iron part of a
solenoid or relay. The other component is the field winding
or field magnet. The role of the "field" component is
simply to create a magnetic field (magnetic flux) for the
armature to interact with, so this component can comprise
either permanent magnets, or electromagnets formed by a
conducting coil.
The armature, in contrast, must carry current so it
is always a conductor or a conductive coil, oriented normal
to both the field and to the direction of motion, torque
(rotating machine), or force (linear machine). The
armature's role is two-fold.
The first is to carry current crossing the field,
thus creating shaft torque in a rotating machine or force
in a linear machine. The second role is to generate an
electromotive force (EMF). So the real problem may lie at
the fact that
"THERE IS NO FIELD CURRENT ALONG THE FIELD WINDINGS
WOUNDED OVER THE ARMATURE".......
| Is This Answer Correct ? | 4 Yes | 0 No |
Why high voltage lines (overhead ) are called high tension lines?
what is the maximum load in MDB,SMDB and DB
How to calculate HV Cable Sizing & what are the factors to be considered for selection?.
how to calculate kA rating of device?
3 Answers Siemens, Vijai Electricals,
What is mechanical interlock?Explain the uses?
what are types of ups?
in a transmission line the aluminium cor is sarrounded and in between there is a another type of matrial what is that?
What is the main difference b/t Earth leakage relay & Earth fault relay.I want protect my LT panel(Distribution Panels)which relay have to propose.......
why is one voltage transformers (instead of three ) installed at the entrence of the incoming line in a substation.
in alternator how we can give power to rotor ? its power is AC or DC ?
what is the difference between ac motor and dc generator
When we connect the large capacitor bank in series ?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)